Thanks for your reply. Its works for me.

I was able to successfully print by using the default settings for a prusa 3i printer and changing the print bed size to match that of the dittopro

Good question. Cura 2.6.0.

What benefits come from tree supports? I took a look at them in Cura and they don't seem very rugged to me.

There's just about a 0% chance that you also use the CR10v2 and have already nailed down it's MVS for generic PLA is there?

What does maximum volumetric speed mean? That you can make the printer print faster?

I have increased the temperature by 10 which seems to have helped very marginally however I am still having the same banding issue 🙁

In terms of the banding, the belts are tight. Could they perhaps be over tightened? What sort of effects would that have? I have also checked the X ca...

The gaps on the Z surface seem to have been resolved with the combination of the slight Esteps alteration as well as by increasing the nozzle temp.

I did The Esteps changed from 94 to 94.88, so really quite minimal which was surprising.