Notifications
Clear all
Ansys
2
Posts
2
Users
0
Reactions
1,158
Views
Topic starter
30/04/2022 11:44 am
Is there any guide to determine which part/or surface need to be Target/Contact in Ansys mechanical?
I try to use automatically detected contact by Ansys and have no idea which surface shout contact & target.
03/06/2022 1:09 pm
In generally contact & target surface define by considering nature of the solution and if it's mechanism their working/function. However following guide will wok for most of the behavior.
- If a convex surface comes into contact with a flat or concave surface, the
flat or concave surface should be the Target surface. - If one surface has a coarse mesh and the other a fine mesh, the surface with the coarse mesh should be the Target surface.
- If one surface is stiffer than the other, the stiffer surface should be the Target surface.
- If one surface is higher order and the other is lower order, the lower order surface should be the Target surface.
- If one surface is larger than the other, the larger surface should be the Target surface.
